Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems: •MissingParts •Installat
If the front driver's side mounting location has the metal bracket, remove the bolt that attaches itto the vehicle using a 10mm socket. Discard
Insert the threaded plate into the hole from which the rubber plug was removed.Using the 6mm bolt [L] and the washer [M], attach the brace to the vehi
Pull down on the brace to put tension on the threaded plate and tighten the bolt using a 13mm socket.To reattach the cover at the driver's front
Reattach the cover to the metal bracket with the bolt previously removed using a 10mm socket.If there is no metal bracket at the front location, the d
Slide two square head bolts [J] into the channels on the underside of the running board.Line the bolts in the running board up with the slots in the b
Slide the board to the desired location from front to rear. A tape measure may be used to insurethe board is centered between the wheel wells. Slide
Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe
PLATEDZ 16201DZ 16202DZ 16203X2PN 835X6PN 714X6BRACKETBRACKETBRACKETBRACKETB 1749LPX1B 1749RPX1B 1750LPX2B 1750RPX2PN 525X6PN 527X6PN 524X12PN 526X12P
WRENCH/RATCHET10mm, 13mmTAPEMEASURESCREWDRIVERTIN SNIPSThere are three brace mounting location on each side of the vehicle.Locate the clips that attac
Remove the plastic clips from the vehicle. Do this by using a screwdriver to release the centerpost in the clip.Once the center post has been release
There are a series of rubber plugs on the outside of the pinch weld. 3 of these locations willalso be used to mount the bracing.For the middle and re
For the front brace:The plug directly in front of the metal bracket will be used. If your vehicle does not have a metalbracket at this location, then
For middle and rear braces:Insert the small threaded plate into the hole where the plastic clip was removed in step 2.Once the small threaded plate ha
Once both threaded plates have been inserted, slide the plastic cover tab in between the brace and the vehicle to secure the cover.Pull down on the br
Kommentare zu diesen Handbüchern