Dee-zee FX31930 Bedienungsanleitung

Before returning this product to the store of purchaseContact Dee Zee if you experience the following problems:    •MissingParts   •Installat

Place the running board on the braces with the bulb seal up against the rocker panel.The back lip of the board must sit on the outside of the rocker p

Align the board with the vehicle and make sure that the mud flap is up against the wheel well.Once the board location is set, use a 7/16" socket/

Attach the mudflap using four #10 screws [N].13Check to insure that all hardware has been tightened.Repeat process for other side of vehicle.FX 31927

Dee Zee Running Board Installation InstructionsCongratulations on your purchase of a quality Dee Zee product. Dee Zee isrecognized as having the highe

REG CABX2REG CABX2MXFLSLX1VARIESX2B 2008RPX3B 2008LPX3MXFLSRX18mm X 25mmFLANGE HEAD BOLTDee Zee FX Running Board Installation Instruction (2009 - Curr

WRENCH/RATCHET3/8", 7/16"13mm, 15mmTIN SNIPS 1/8" DRILL BITPlace the bulb-seal gasket [E] onto the backlip of the runing board [A]. C

Place the end cap [O] onto the running board as shown below. The image shown is the drivers sideside box board. Secure the end cap in place using a

Locate the hexagon shaped holes on the inside of the rocker panel. There will be two holesat each mounting location. The passenger side is shown bel

Use the nutsert set tool [F] to crimp the nutserts in the holes.Hold the nut on the set tool with a 15mm wrench. Tighten the bolt in the set tool wit

When the brace is put up to the vehicle mounting location, the threaded plate must go into the large slot above the nutserts previously installed.Thre

Remove and discard the small cladding located in front of the front door.Align the bolt in the channels on the bottom of the running with the slots in