GRILLE GUARD
2014 GMC SIERRA 1500
EXCLUDES DENALI
Page 3 of 8 9-25-13(DP)
a. Vehicles with tow hooks: Once adjusted side to side and after the 8mm hardware is tightened,
insert the short factory tow hook bolt, (one per tow hook), through the remaining hole in the Frame
Bracket and back into the tow hook. Repeat to reinstall the passenger side tow hook bolt.
5. Through the radiator opening, locate the square tube support braces running up at an angle from the top
of the frame channel to the bottom of the hood release mechanism, (Figures 11B, 13 & 14). Select the
driver side Inner Top Bracket and (1) Backing Plate, (Figure 11A). Hold the Inner Bracket up to the bottom
of the brace tube with the Backing Plate over the top. Bolt the Brackets together around the square tube
with (2) 6mm x 25mm Hex Bolts, (2) 6mm Lock Washers and (2) 6mm Flat Washers, (Figure 11B). Leave
loose at this time. Repeat this Step to install the passenger side Inner Bracket and Backing Plate.
6. Reinstall the plastic grille if previously removed.
7. Select the driver side Outer Top Bracket, (Figure 12). Insert the Outer Bracket through the grille and up to
the Inner Top Bracket assembly, (Figure 13). Slide the Bracket assembly up or down the tube to match up
the Outer Top Bracket to the hole in the Grille Guard upright. Bolt the Outer Bracket to the top of the Inner
Bracket with (2) 6mm x 25mm Hex Bolts, (2) 6mm Lock Washers and (2) 6mm Flat Washers, (Figure 15).
Leave hardware loose at this time.
8. Line up the outer bent end of the Top Bracket with the hole in the Grille Guard upright. Bolt the bent end of
the Outer Top Bracket to the upright with (1) 10mm x 25mm Button Head Allen Bolt, (2) 10mm Flat
Washers and (1) 10mm Nylon Lock Nut, (Figures 15 & 16).
9. Repeat Steps 7 – 8 for passenger side Top Bracket assembly installation, (Figure 14).
10. Level and adjust the Grille Guard and fully tighten all hardware including bumper, bumper bracket, tow
hook if equipped and all Grille Guard Bracket hardware. IMPORTANT: Adjust the position of the Top
Brackets so that they cannot come in contact with the plastic grille, (Figures 13 - 15).
11. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over
the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used
also to clean the Grille Guard.
For gloss black finishes: Mild soap may be used to clean the Grille Guard.
(2 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern